( H2 + CO ) / CO2 molar ratio B-6 A-2 E-1 Time-on-stream (hr) Figure 14.—Comparison of hydrogen and carbonmonoxide to carbondioxideratio. ... the (H2+CO)/CO2ratio increases with time because both H2 and CO2 concentrations ... that as the activity and selectivity of the catalytic materials apparently drop-off, the ratio of (H2+CO)/CO2 is increased as seen by the data in figure 14. This particular affect
Stream Name VapFrac T [C] P [kPa] Mole Flow [kgmole/h] Fraction [Fraction] HYDROGENCARBONMONOXIDECARBONDIOXIDE WATER OXYGEN NITROGEN Fuel In /mixtoab /sulfurrem /w1 /w3 /wa1 /waf1 Water In /wf5
38% hydrogen, 12% carbondioxide, and 10% carbonmonoxide. After the watergas ... with the gas compositions from iso-octane (Fig. 2), the hydrogen percentage and the ratio of CO2/CO were lower with gasoline. This is partly due to the lower H/C ratio
monoxide yield were achieved when CO2/CH4 ratio was equal to 1.0 and O2/CH4 ratio equal to 0.2. However, higher hydrogen and carbonmonoxide yield were obtained when CO2 ... the hydrogen yield and carbonmonoxide yield shared the same reaction profile at all
Gas Yield, dry vol % CO H2 CO2 Temperature, Fahrenheit Figure 3: Gas yields for carbonmonoxide ( ), hydrogen ( ), and carbondioxide ( ), dry volume percent. ... The dry gas phase yields are shown in Figure 3 for carbonmonoxide, hydrogen, and carbondioxide.
Average Metal Affected, mm Molten Zinc Attack 50 Hours at 850°F (454°C) 556™ alloy ULTIMET C. STEEL 309SS Comparative Resistance to Sulfidation Attack Environment: Argon-5% Hydrogen-5% CarbonMonoxide-1% CarbonDioxide-0.15% Hydrogen Sulfide
Density (g/mL) 0.00009 Styrofoam Cork Oak Sugar Density (g/cm3) Fluid Solid Hydrogen Helium Air Oxygen CarbonmonoxideCarbondioxide 0.002 Aluminum Salt Ethyl alcohol Iron Machine oil Stainless (e.g. diesel) steel Water Nickel Seawater Copper ... reasoning. You are a manufacturer of carbonmonoxide detectors. One of your employees
products of reforming are hydrogen, methane, carbonmonoxide and carbondioxide ... catalyst are hydrogen, methane and carbonmonoxide. All these products are present ... in a hydrogen flow at 5500C in the reactor for 4 h just before the experiment. The catalyst