✓ Graphs ✓ Tables ✓ Reports
 
Format: www.xyz.com or *.gov
Where ▼
Where ▲
Date:
Note: Results will be PDF and Excel – which we can date reliably. For PDFs, it will either be the date the PDF was creater, or the date visible in the graph or chart.
When ▼
When ▲
What ▼
What ▲

Data & statistics on Powder particle velocity distribution – 18885 results
Hover over me
Powder particle velocity distribution

Powder particle velocity distribution

www.jwri.osaka-u.ac.jp/publication/trans-jwri/pdf/341scp-zhang.pdf

to be isothermal because the residual time of powders in the plasma plume is not long enough. 3.2.2 Velocity Distribution of the Powder Particles Injected into the Plasma Plumes almost the same as that without powder injection, while the plume length shrinks down ...
Fig.9 A picture of plasma plume with Al2O3 powder Powder: Al2O3 Current: 450A Gas flow: 150L/min Percentage(%) Velocity (m/s) Fig.10 Powder particle velocity distribution

Nov 2005 | www.jwri.osaka-u.ac.jp
Original Url: http://www.jwri.osaka-u.ac.jp/publication/trans-jwri/pdf/341scp-zhang.pdf
Comparison of bubble pierced length at height 0.39 m for different powders. Superficial velocity is 0.210 m/s for the large particle powder and 0.133 m/s for the two other powders.
29 more results from this site ▶

Comparison of bubble pierced length at height 0.39 m for different powders. Superficial velocity is 0.210 m/s for the large particle powder and 0.133 m/s for the two other powders.

teora.hit.no/dspace/bitstream/2282/301/1/Thesis_15_07ny.2005.pdf

velocities are 0.133 m/s for the small particle powder and the mixed powder, and 0 ...
fluidization velocity. The large particle powder started to fluidize at a superficial ...
19 m/s. This means that the excess gas velocity for the experiments with large particle powder

Jul 2005 | teora.hit.no – 29 more results from this site
Original Url: http://teora.hit.no/dspace/bitstream/2282/301/1/Thesis_15_07ny.2005.pdf
Measured particle velocity distribution of the Al12Si powder.
49 more results from this site ▶

Measured particle velocity distribution of the Al12Si powder.

asm.confex.com/data/manuscript/asm/itsc07/Paper_15525_manuscript_716_0.pdf

Particle Velocity Figure 7 presents the measured particle velocity distribution for the Al-12Si under the spraying conditions stated above. The particle velocities range ...
conditions, the measured particle velocity distribution for the Al-12Si+30% SiC is showed ...
Particle velocity (m/s)

Dec 2006 | Asm – 49 more results from this site
Original Url: http://asm.confex.com/data/manuscript/asm/itsc07/Paper_15525_manuscript_716_0.pdf
Demonstrates the distribution of the flow velocity u , the pseudo-temperature v, and solid volume fraction across the gap for Case 1 and Case 2. The results of Case 1 exhibit a similar trend to those obtained by McKeague and Khonsari (1996). It is shown that particles slip at the boundary and energy produced by means of slippage are supplied from the boundary to the powders in the interior of the gap. ...

Demonstrates the distribution of the flow velocity u , the pseudo-temperature v, and solid volume fraction across the gap for Case 1 and Case 2. The results of Case 1 exhibit a similar trend to those ...

www.cressnet.ir/Journals/J_TRIBOLOGY/TRIBOLOGY_2000_JAN.pdf

characteristics of a powder lubricant as it is sheared between the clearance space of two infinitely wide parallel plates. The top plate is stationary, the velocity of bottom plate is U L 4.6 m/s, and the thickness of the gap is equivalent to 14 particle

Jan 1996 | www.cressnet.ir
Original Url: http://www.cressnet.ir/Journals/J_TRIBOLOGY/TRIBOLOGY_2000_JAN.pdf
The simulated and measured radial profiles, of temperature and velocity of an alumina powder, in the plasma jet at 10 cm from the torch exit. For both characteristics, simulated values have the same tendency but are superior to those of experiment. The measured velocity of the particles decreases when the radial distance from the axis increases. The temperature computational profile is about 5 % superior ...

The simulated and measured radial profiles, of temperature and velocity of an alumina powder, in the plasma jet at 10 cm from the torch exit. For both characteristics, simulated values have the same ...

jets.poudres.free.fr/IMG/ISPC-664.pdf

is injected with an external injector [10]. The size distribution of alumina powder ...
to the commercial powder size distribution. 4. Conclusion Jets & Poudres software appears ...
For single particles the agreement is good within 5%. For a powder load the code gives

Apr 2003 | Jets&Poudres
Original Url: http://jets.poudres.free.fr/IMG/ISPC-664.pdf
Molten particles velocity in the HF plasma flow versus the plasma radius (r) at different cross sections (Z). Experimental conditions : Argon plasma, frequency 4 MHz, Power 25 kW, Q1=5 slm, Q2=30 slm, Q3=30 slm, initial particles size +63-80 µm, mass flow of silicon powder 0.02 Kg/h.

Molten particles velocity in the HF plasma flow versus the plasma radius (r) at different cross sections (Z). Experimental conditions : Argon plasma, frequency 4 MHz, Power 25 kW, Q1=5 slm, Q2=30 slm ...

membres.multimania.fr/fredo74/Images/PDF/ISPC14F.pdf

the axial flow, the particles velocity distribution is significantly narrower (RMS=2m ...
The registration of axial particle velocity is plotted on the figure ...
at each 4 mm. The particle velocity presented figure 4, for the three Z cross sections

Oct 2001 | Lycos Tripod - Tripod
Original Url: http://membres.multimania.fr/fredo74/Images/PDF/ISPC14F.pdf
Gives the gas velocity distribution along height for case 1. It can be seen that when there is no particle loading, gas velocity increases logarithmically with the height. When particle loading is introduced, gas velocity is greatly reduced. It implies that a part of gas momentum must be transferred into particle phase. Fig. 3 shows that the gas shear stress and the total stress vary along height for ...

Gives the gas velocity distribution along height for case 1. It can be seen that when there is no particle loading, gas velocity increases logarithmically with the height. When particle loading is ...

dspace.imech.ac.cn/bitstream/311007/44993/1/SCI-J2011105.pdf

s;r R N k− + Δt∑s=1 ∑r =1 fx;s;r 2 k;l ð10Þ Y. Zhang et al. / Powder Technology 209 (2011 ...
The ↓ ↑ z=z are l, l l, l l, l l, l k− momentum exchange due to particle collision at z = z 1 and z = z 1 k+ R 1 R 1 k− À 2 Á ...
and k− ð11Þ k− ð12Þ ð13Þ Table 1 Cases. τ0 (Pa) No. Particle diameter (mm) the inlet and the outlet both in X and Y directions. When a particle leaves

Mar 2011 | IMECH-IR: 主页
Original Url: http://dspace.imech.ac.cn/bitstream/311007/44993/1/SCI-J2011105.pdf
SEM micrographs of as-received feedstock powder particles: (a) nickel, (b) copper, (c) aluminum and (d) the corresponding particle size distribution [71, 72].

SEM micrographs of as-received feedstock powder particles: (a) nickel, (b) copper, (c) aluminum and (d) the corresponding particle size distribution [71, 72].

digitool.library.mcgill.ca/thesisfile92381.pdf

(a) (b) (c) (d) The volume-weighted powder size distributions were measured using a laser diffraction particle size analyzer (LS320, Beckman Coulter, Miami, FL ...
velocity of nickel particles under the gas temperatures 200, 400 and 600 ° are 596, 698

Apr 2010 | DigiTool main menu
Original Url: http://digitool.library.mcgill.ca/thesisfile92381.pdf
Particle distribution according to the geometrical size. Initial mixture is 66 Torr of O2 + 133 Torr of H2 + 2 ml of SiCl4 + 2 ml of CCl4. The particle size of obtained composite powder Si-C-Ox is also smaller than pure nanodispersed silicon dioxide. The average particle size decreases from 134 to 47 nm. 5. Influence of Subsequent Effect of Pulsed Electron Beam Process of nanodispersed oxide synthesis ...

Particle distribution according to the geometrical size. Initial mixture is 66 Torr of O2 + 133 Torr of H2 + 2 ml of SiCl4 + 2 ml of CCl4. The particle size of obtained composite powder Si-C-Ox is ...

www.congress-2006.hcei.tsc.ru/cat/proc_2004/13/Paper_112.pdf

of the initial stage of nucleation on the condensation velocity. The size of formed powder ...
particles of silicon dioxide leads to their enlargement according to a definite mechanism. The particle formation with regular spherical shape with large size

Jul 2004 | 2nd International Congress on Radiation Physics, High Current Electronics, and Modification of Materials with Particles beams and plasma Flows
Original Url: http://www.congress-2006.hcei.tsc.ru/cat/proc_2004/13/Paper_112.pdf
Computed particle mean velocity along the diameter of the injector at the exit point (the -r coordinate denotes the outer half of the curvature); carrier gas flow rate: 4 slm, zirconia powder (test 2, Table 1)

Computed particle mean velocity along the diameter of the injector at the exit point (the -r coordinate denotes the outer half of the curvature); carrier gas flow rate: 4 slm, zirconia powder (test 2, ...

www.cityofmaterials.com/content/TSS/JTST/jtst_10_02_464.pdf

injector, particles have a more uniform distribution similar to the flat velocity profile ...
Figure 10[18] compares the computed radial distribution of particle mean velocity at the exit of a straight and a curved injector (R = 12.7 mm). Over 90

Jan 2001 | City of Materials | ASM International
Original Url: http://www.cityofmaterials.com/content/TSS/JTST/jtst_10_02_464.pdf
Related searches: cumulative particle size distribution for small particle powder, particle size distributions of solids, particle size distribution of different flavoring powders, the variance of bed pressure drop versus superficial gas velocity, particle size distributions of powders b and c before calcination

Hints & help

Language. English only please... for now.
Phrase search. You can use double quotes to make phrases (e.g. "mobile phones").
Booleans. You can use a plus ‘+’ to make a word mandatory, or a minus ‘–‘ to exclude it (e.g. +gas –oil production)
Vocabulary. We have only limited synonyms - please try different words in your query.
Questions? Please email us: helpdesk [at] zanran [dot] com